The traffic-shaping may not end up working like you expect with your current percentages. I notice that your combined percentages don't equal 100%, which is kinda strange. Then create the corresponding firewall rules and assign the traffic to your queues. Skip the wizard and create your queues manually, keeping it as simple as possible. The QoS functions fine for the majority of users. Is what I used to be able to do possible on pfSense? One of the reasons I went down the pfSense route rather than a faster Asus router (RT-N66U couldn't do 220/22 AND QoS) was decent QoS, however from reading around this evening suggests this incredibly powerful piece of software can't do something I could do on a consumer router? I've spent about 4 hours trying to work this out with absolutely no success. Policy maps are used to apply the appropriate quality of service (QoS) to network traffic. A CLI that allows you to define traffic classes, create and configure traffic policies (policy maps), and then attach the policy maps to interfaces. Trying to adjust the limits it complains about being > 100%, and the shared box is ticked. MQC Modular quality of service command-line interface. Using the wizard I get limited to 53Mbit of 220Mbit!? (25%!?) Top = priority (Up/Down bandwidth limits) I used to do on Tomato firmware something like Read around after installing pfsense I might be disappointed that I can't do the following…
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |